-
Language
-
Shopping cart is empty
-
-
Shopping cart is empty
-
Smart G02461 car windshield repair kit
G02461 SMART GLASS REPAIR KIT
| Shipping within | 24 hours |
| Shipping price | The Lack Of |
| The Availability Of |
Small quantity
1
couples
|
| The Weight Of The | 0.2 kg |
| GEKO | |
| The bar code | |
| EAN | 5901477163500 |
Order tel: +48 789 134 073
| Leave your phone |
The Easy windshield repair kit allows you to repair windshields and glass headlamps in an easy, quick and, above all, cheap way. Perfect for the liquidation of cracks and chips resulting from, for example, a stone impact. It works well when repairing chipping and small longitudinal cracks, it effectively stops further cracking of the glass. After application and drying, the adhesive becomes transparent, making the repaired area practically invisible.
Product Characteristics:
an easy, quick and cheap way to repair cracks and chipping
the set is reusable
effectively stops further cracking of the glass, reducing the stress at the crack site
After drying, the glue becomes colorless, thanks to which the repaired place is practically imperceptible
safe to use
Directions for use:
Use the red pin to remove the glass shards and clean the residue. Use a cloth
for cleaning the damaged area. Tear off the protective paper and stick the gasket
self-adhesive to the windshield, aligning the hole with the center
damage. Tear off the front of the adhesive seal and place the seal
o-ring in the center of the bore. Glue the base to the self-adhesive gasket,
making sure that the hole on the stand is facing up. Use your thumbs to press down firmly along the edge of the base.
to ensure a tight connection with the gasket.
Take the repair resin and cut off the tip of the bottle. Gently squeeze the base of the bottle about three times.
There should be approximately 2 or 3 drops of resin (the amount needed may vary depending on the extent of the lesion).
Use a mirror to check that enough resin has been introduced.
Screw the syringe onto the base hole, pull the plunger up and lock it in the other clasp.
Hold the syringe in this position for 10-15 minutes to remove any air bubbles.
Unscrew the syringe from the base and screw it on again.
Push the plunger back into the syringe and lock it with the first clasp.
Leave the syringe in this position for 10-15 minutes.
Unscrew the syringe and use a razor blade to remove the base and the adhesive seal from the glass.
After removing the base, gently remove any resin residue with a razor blade.
Apply 1 to 2 drops of resin to the center of the damaged area. Put the hardening film on the damaged one quickly
area and use a razor blade to smooth the foil, making sure the resin is evenly spread under the foil.
If possible, you can fix the foil with adhesive tape (not included).
The resin will cure naturally in 15-20 minutes under direct sunlight.
After the resin is cured, remove the hardening film. Holding the razor blade at a 45-degree angle, gently scrape it
excess resin
- Promotions
160.00
48.00
2999.00
590.00
599.00
1599.00
- Manufacturers
